Stretcher Bar Puller
The stretcher bar pullers are produced from high grade steel. This combines strength with high surface hardness: a must for reduced wear when using high tensile wire.
-
Used in combination with the stretcher bars
-
Makes quick work of stretching most woven wire fences
-
High tensile chain to pull 3000lbs
-
Replaces the come-along
-
Comes with 22 ft. of chain
-
Comes with 2 hooks and swivels
Steel, Fence Stretcher Bar & Wedges
The fence stretcher bars ensure that the proper tensioning of our high tensile fences.
-
Tension up to 1/4 mile of fence at a time
-
Quickly and easily holds wire for tensioning
-
Use of stretcher bar puller is highly recommended
-
No slippage
-
Lengths of 52" - 82" - 102"
-
Fast splicing means more fencing can be done in one day
Fencing Tool
This lightweight high quality fencing tool will make life easier on the fence line.
.png)
-
Cuts high tensile wire
-
Splices 12 1/2 ga. high tensile wire
-
Removes staples
-
Strips electric fence cable
Crimp Sleeves
Join fence lines in a fraction of the time with this extra long (3/4") crimp sleeve.
.png)
-
Perfect companion to the Fencing Tool
-
Will not split under heavy loads
-
Joins 12 1/2 ga. high tensile wire
-
Holds up to 1500 lbs
-
Will not rust
Barbed Staples
Barbed staples give added holding power, virtually eliminating staples working themselves out of the post due to expansion and contraction of the wood.
-
Available in 9 ga. commercial galvanized and 8 ga. heavy galvanized (class 3)
-
Packaged in 50lb & 10lb convenient carry packs.
-
Sizes 1 1/4" to 2"
-
Recommended as the omly staple to use in conjunction with our high tensile fencing system.
Post Clips
Post clips are. a quick and secure method to attach wire to steel posts.
.png)
Wire Twister
The Wire Twister is a great tool to add into your toolbox for fencing. Just grab your 3/8th” cordless or electric drill to attach and within in seconds it creates the most professional looking wrapped wire.
Step 1:
Bend wires on end of rolls at 90 degrees to each other. Wire ends 4"+
Step 2:
Join together overlapping one another.
Step 3:
Bend around wire to lock rolls.
Step 4:
Tighten roll then apply wire twisters.
Step 5:
Apply power to drill until finished.
Step 6:
Nice tight finish!
Tips:
1. The tighter the rolls the better the machine runs.
2. Twist the drill when you are close to the slot in the gear rather than powering the drill.
3. If joining rolls on the ground put your foot on squares to apply tension.
4. Great for building gates.
5. 3/8" cordless drill required.